C2 Seal 20 Liters C2S-20

Crete Colors C2 Seal Features

• Low odour coloured concrete sealer. Easy to apply. Fast drying.
• Produces a long lasting, high gloss finished the concrete floor with maximum light reflectance.
• Eliminates the need for floor waxes, liquid polishes and conventional resin-based coatings.
• Further improves the surface sheen and stain resistance of floors treated with C2 Super Hard, C2 Hard or C2 Hard Blend.
• Tested and conforms to California Collaborative for High-Performance School Indoor Air Quality standards. Use can contribute to LEED® for Schools points (EQ Credit 4).
• Gloss and hardness do not reduce slip resistance.
• Breathable and UV stable. Will not yellow, discolour, peel or flake.
• Non-flammable. Non-toxic. Low odour.

Typical Coverage Rates

Variations in concrete quality, porosity, job site conditions, temperature and relative humidity will affect coverage rates and drying times.

Apply C2 Seal at the highest coverage rate possible. Applications to highly polished floors yield the highest coverage rates. Two thin applications achieve better results than one heavy coat.

Estimated Coverage Rates

The following coverage rate is offered for estimating only. See below for instructions on calculating project-specific target coverage rates.

FIRST COAT

• 25 –40 m2 /L
• 1000–1500 ft2 / US gal

SECOND COAT

• 40 – 60 m2 /L
• 2000–2500 ft2 / US gal

Calculating Project-Specific Coverage Rate

1. Prepare the test section in accordance with “Preparation” information above. Surfaces must be clean, dry and absorbent.
2. Add 3.5L of C2 Seal to a clean, pump-up sprayer. Apply according to Application Instructions below. Repeat as necessary to achieve the desired level of finish.
3. Measure the test area to establish the target coverage rate per liter. Protect the treated area from moisture for 24 hours following application.